Universal Electronics Millenium 4 Uživatelský manuál stáhnout pdf (Strana 34)

PROGRAMMING AUDIO CONTROL

Using the Millennium 4’s Audio mode, you can

also control an audio component, a stereo receiver,

or a stereo amplifier.

Locate the brand name of your audio component in

the one of accompanying code lists (starting on the

next page). Write it in the appropriate space.

Stereo Receiver Brand: ________________________

Stereo Amplifier Brand: _____________________

The brands are listed in alphabetical order with

popular codes listed first. You will use one of these

codes to program the Millennium 4 to operate

your audio component:

1. Turn on the audio component (or DBS

receiver to control its audio service).

2. On the Millennium 4, press AUDIO once.

Press and hold SETUP until the LED

blinks twice, then release SETUP.

3. Enter the first four-digit code for your

audio component. If you perform this

procedure correctly, the LED will blink

twice.

NOTE: If the LED did not blink twice after

entering the code’s last digit, then repeat steps 2

through 3 and try entering the same code again.

Aim the Millennium 4 at your audio

component and press POWER once.

The unit should turn off. If it does not

respond, repeat steps 2-3, trying each

code listed for your brand until you find

one that works. If it still does not work ,

try searching for the code (see Searching

For Your Code on page 38).

5. Write your audio component code in the

boxes below for future reference.

NOTE: Remember, to use the Millennium 4 to operate

your audio component, press AUDIO first.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Žádné komentáře

Universal Electronics Millenium 4 Uživatelský manuál Strana 34