Universal Electronics OCAP 5 Uživatelský manuál stáhnout pdf (Strana 17)

www.urcsupport.com/atlasocap

PROGRAMMING CABLE ID LOCK

The Atlas OCAP 5-Device Remote Control is locked at

the factory to operate your cable provider’s set top box.

However, if you have another brand or model of cable

converter or satellite service that you would like to

control, then you’ll need to perform the following steps

to unlock the ID Lock, enter a new manufacturer’s code,

and lock the ID Lock again.

1. Turn on the cable converter.

4. Perform the instructions under

“Programming Device Control” on page 10 to

program device control for the desired cable

converter or satellite receiver.

When you are done, perform steps 5 and 6 on

this page to again lock the cable ID Lock.

PROGRAMMING MACRO KEYS

The Atlas OCAP 5-Device Remote Control includes two

macro keys (located directly below the MUTE and LAST

keys). Macro keys allow you to set up key macros to

activate certain keys in a specific order. For example, you

can set up a key macro to change the channels on your

TV, raise or lower the volume, and start recording on

your VCR, all with the touch of one key. If you want to

change the macros stored in a previously-programmed

macro key, you’ll need to clear the key first (see

“Clearing a Macro Key” on page 18).

2. On the remote control, press CBL once; it will

blink once. Then press and hold SETUP until

the CBL key blinks twice.

3. Enter 9 8 2. The CBL key will blink four

times, indicating ID Lock is unlocked.

5. On the remote control, press CBL once; it will

blink once. Then press and hold SETUP until

the CBL key blinks twice.

6. Enter 9 8 2. The CBL key will blink twice,

indicating ID Lock is again locked.

Atlas OCAP M1056.fm Page 17 Tuesday, March 24, 2009 4:45 PM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 87 88

Žádné komentáře

Universal Electronics OCAP 5 Uživatelský manuál Strana 17